I promised I would post the directions for this project a month ago. Sorry for the delay.
Supplies needed:Felt :: 1" Button :: 3/4" Art Buttons :: Pattern :: 18 gauge wire
24 gauge wire :: Small pot
Make your pattern, I drew around the 1" button then added petals. Cut out the flower.
Cut 2" of 24 gauge wire, I used copper, any kind can be used. Center the 3/4" Art Button on the flower. Use a needle or piece of the 24 gauge and poke it through the button holes felt, wiggle it around to separate the fibers of the felt. Fold your 2" piece of wire lightly in half. From the back side of the flower, push the wire through the button holes to the top and twist once. Lay the wire down flat so it is out of the way. Putting the stamen wire in now keeps these 2 pieces together while adding the stem wire.
Cut 6" of 18 gauge wire. From the backside of the flower push the wire through one of the button holes. Approximately 1 3/4" through the flower, bend 90º, as you would when making a wire loop. Slide the long end of the wire up further from the top, enough so you can finish bending the wire to go back down through the other button hole. The wire will naturally want to curve and cross. Straighten a little as you go to make it easier to push it down through both holes. With your wire straigthened and through both button holes, slide the 1" button onto the wire and through both button holes. I used shell buttons because it's what I could find in my studio. Plastic would work also.
Wrap the short end of wire around the long piece of wire. Use your pliers to bend the tail of the wire into the stem.Curl your stamen wire.
Repeat this as many times as you would like for your bouquet.
I used a small terra cotta pot for my flowers. A yogurt cup would work. Decorate the container. Put styrofoam, flower foam or in my case, clay (it was within reach in the studio), in the bottom of the pot. Place wood Excelsior, paper shred, easter grass, yarn, whatever you like on top. Arrange your flowers. Viola!! A gift your mother or yourself.
Posts
